Kore carrier board

The Spektreworks Kore carrier board is a great way to upgrade your Cube autopilot. It comes with pre installed PDB capable of 140A continous current. A current and voltage sensor. Internal BEC for payload (5v and 12v). All the connections are placed conveniently for your multirotor. The Cube Orange+  is sold seperatly. NOTE: Pixhawk 2.1 Cube NOT included.

Specifications

• Up to 12-cell Lithium battery (50.4V)
• 140A continuous current with 280A surges
• Power and signal for ESCs conveniently located in corners
• 12V navigation light power available at each cornerBuilt-in power distribution
• Built-in voltage and current sense
• Redundant power supplies for flight critical components
• Payload connectors with resettable fuses for 5V, 12V, and direct battery power
• Good power and error indicator lights
• Built-in buzzer with volume control
• Connectors for every function of Pixhawk Cube
• Easily accessible PWM voltage level selector (3.3V or 5V)
• Resistant to ground bounce on PWM signal
• Kore carrier board connectors compatible with standard ProfiCNC carrier board
• Connector ports for debugging IO and FMU processors

Standard cables

• 4-pin JST GH
• 6-pin JST GH

Payload power cables

• 4-pin Clik-Mate 1.25mm (for 5V payload power)
• 5-pin Clik-Mate 1.25mm (for 12V payload power)
• 6-pin Clik-Mate 1.25mm (for battery payload power)

Support and assistance

or more information and installation instructions for the Cube Autopilot, visit the Kore Manual. If you need any advice or additional information about your drone project, feel free to contact us.

Manufactured by CubePilot