Cubepilot Power Brick mini

The Power Brick Mini is the standard power module for the Pixhawk 2.1 The Cube. It supplies the Cube with a steady power source while providing current and voltage readings to the autopilot system.

What's inside

1 x Power Brick Mini (with or without XT60)

Specifications

• Maximum input voltage: 8S
• Max continuous current sensing: 30A (for higher current ratings, consider other sensors in our webstore)
• Max burst current: 100A
• Connectors: XT-60 or without XT-60
• Weight: 14g
• Size: 53 x 18 x 14 mm

Power module connection

1. Connect the power module to the POWER1 port via POWER cable. If there is a second battery monitor, connect it to the POWER2 port.
2. The Cube will turn on immediately after the battery is connected.
3. Connect the XT60 on the other side of the power module to the motor system and loads.

Support and assistance

For more information and installation instructions, check out the user guide. If you need any advice or additional information about your drone project, feel free to contact us.

Manufactured by CubePilot