Kore Carrier Board

241,00

The Spektreworks Kore carrier board is a great way to upgrade your Cube autopilot. It comes with pre installed PDB capable of 140A continous current. A current and voltage sensor. Internal BEC for payload (5v and 12v). All the connections are placed conveneintly for your multirotor.

Out of stock

Description

The Spektreworks Kore carrier board is a great way to upgrade your Cube autopilot. It comes with pre installed PDB capable of 140A continous current. A current and voltage sensor. Internal BEC for payload (5v and 12v). All the connections are placed conveniently for your multirotor.

The Cube is sold seperatly: The Cube Orange

FEATURES AT-A-GLANCE

  • Up to 12-cell Lithium battery (50.4V)
  • 140A continuous current with 280A surges
  • Power and signal for ESCs conveniently located in corners
  • 12V navigation light power available at each cornerBuilt-in power distribution
  • Built-in voltage and current sense
  • Redundant power supplies for flight critical components
  • Payload connectors with resettable fuses for 5V, 12V, and direct battery power
  • Good power and error indicator lights
  • Built-in buzzer with volume control
  • Connectors for every function of Pixhawk Cube
  • Easily accessible PWM voltage level selector (3.3V or 5V)
  • Resistant to ground bounce on PWM signal
  • Connector-compatible with standard ProfiCNC carrier board
  • Connector ports for debugging IO and FMU processors

STANDARD CABLES:

4-pin JST GH
6-pin JST GH

PAYLOAD POWER CABLES:

4-pin Clik-Mate 1.25mm (for 5V payload power)
5-pin Clik-Mate 1.25mm (for 12V payload power)
6-pin Clik-Mate 1.25mm (for battery payload power)

More information on how to install the Kore carrier board: Kore Manual

 

NOTE: Pixhawk 2.1 Cube NOT included.

 

Reviews

There are no reviews yet.

Be the first to review “Kore Carrier Board”

Your email address will not be published.

You may also like…