Airbot Cube+ Here3 combo

645,00

The Airbot Systems Mini carrier board is one of the way to install a Cube on a drone. The Mini carrier board encapsulate all the wiring in a 50.5×57.5mm board, in order to save space and weight for applications which have size limits.

3 in stock

SKU: HX4-06202, HX4-06214, HX4-06213 Categories: ,

Description

Airbot Cube+ Here3 GENERAL : 

Airbot Cube+ Here3 combo

The Airbot Cube+ Mini carrier board PDB combo  is one of the way to install a Cube on a drone. The Mini carrier board encapsulate all the wiring in a 50.5×57.5mm board, in order to save space and weight for applications which have size limits.
The Airbot Systems Power Distribution Board Set can be installed directly under Airbot Mini carrier board set. 
The PDB allows up to 180A through ESC interface and four pairs of low power pads (2 on top/ 2 on bottom). 
The mounting hole are aligned with Airbot carrier board, so the board can be stacked together while separated by small nylon spacers.
 
Airbot Cube+ systems mini carrier board PDB combo FEATURES : 
  • Dual power inputs (redundant power with automatic switch to the second power source when first one fails) 
  • Easy to install on drone (see the mounting pattern above) 
  • Power distribution & voltage protection (providing current to each connector) 
  • Motor PWM signal distribution (up to 8 motors – distributed on corners) 
  • Standard 2.54mm servo PPM/S.BUS/Spectrum RC input (+5v/+3.3v selectable power from carrier board) 
  • AUX VCC pins are connected together. This allows powering the AUX rail externally. 
For more information, please visit:

Vibration Damped IMU board version 2 (Fitted to Cube Orange autopilot, Cube BlueH7 and Cube Yellow)

  • ICM20602

  • ICM 20948

  • MS5611 Barometer

  • All sensors connected via SPI.

I/O ports

  • 14 PWM servo outputs (8 from IO, 6 from FMU).

  • R/C inputs for CPPM, Spektrum / DSM and S.Bus.

  • Analogue / PWM RSSI input.

  • S.Bus servo output.

  • 5 general purpose serial ports, 2 with full flow control

  • Two I2C ports

  • One SPI port (un-buffered, for short cables only not recommended for use).

  • Two CAN Bus interface. (CAN FD for BlueH7 and Orange with CubePilot Logo)

  • 3 Analogue inputs

  • High-powered piezo buzzer driver. (On expansion board)

  • High-power RGB LED. (I2C driver compatible Connected externally only)

  • Safety switch / LED.

Reviews

There are no reviews yet.

Be the first to review “Airbot Cube+ Here3 combo”

Your email address will not be published. Required fields are marked *